How to Remove Write Protection on Windows 11 PC – Guide

If your hard drive is write protected, you cannot write data to it or make changes to your device. The first and most important way to fix this issue is to check the lock key. If the lock key does not work, then you can try changing the drive’s firmware or using a software solution like Data Recovery Wizard.

Some USB flash drives, SD cards or thumb drives have a lock key. So if your Windows 11 PC is telling you that the media is write-protected, you’ll need to look for a write-protect key (aka lock key) on your SD card or USB drive. If the media has a lock key, make sure it is set to write and not read-only. If the SD card or USB flash drive lock button is enabled, but you still cannot make changes to the files stored on the hard disk, try removing write protection using the disk part.

Run Diskpart commands

Launch the Run dialog and type diskpart. You can get there by right-clicking the Start menu or searching for Run.

disk 1 select

fdisk -l This will list the partitions on the disk. ..

edit the record

C:\Windows\System32\Registry Editor This location can be found in the left column of the Registry Editor window.

To find the StorageDevicePolicies key, open Control Panel and go to the Hardware and Sound category. If you don’t see it, create it by right-clicking Control and going to New > Key. Once you find the StorageDevicePolicies key, click on it to open the Policies window. ..

Open the Storage Device Policies window and locate the Write Protect DWORD (32-bit) value. If you don’t see it, you can create it by right-clicking Storage Device Policies and going to New > DWORD (32-bit) Value. ..

Double-click Write Protect and set Value data to 0 if not already.

Close Registry Editor and restart your computer. ..

Final note

How to Remove Write Protection on Windows 11 PC If you have a computer that is running Windows 11, you can use the following steps to remove write protection from the system. This will allow you to use the computer without any problems.

  1. Open the Start menu and type “cmd”. This will open a command prompt.
  2. Type “netstat -an”. This will show you all of the network connections on your computer.
  3. Look for a connection that is listed as “writable”. If there is one, it will be highlighted in blue. Remove it by typing “netstat -a –no-write” and then clicking OK. The connection should now be listed in green.
  4. Type “sc config writeprotection off” and click OK. The computer should now be able to run without write protection enabled